ITronHab01

Front view
Rear view

IP Home automation bridge. Supports iTach API for relay and IR control. Optional POE (24W required).

Initial Setup

API Guide

Technical Specifications

Connectivity
Ethernet1 RJ45 (optional POE)
Wifi802.11 a/b/n
USBUsed for brick mode firmware recovery
Front Panel
Power indicatorRed LED indicates board is powered
Wifi StatusOrange LED indicates Wifi Status
IR OUT [1-3]3.5mm output for IR transmitter
Relay LED [1-8]Red LED indicates status of each relay
IR LearnIR input for learning IR codes
FactoryFactory button
ResetReset button
SerialDB9 Male serial RS232 connector
Rear Panel
Power5mm Barrel Jack, 2.1mm center pin
USBUSB-A Connector
LANRJ-45 10/100Mbps
Relay ConnectorScrew terminal connector
Power
Optional POEMin 24W POE required 
Mains6V – 18V DC 2A
Physical
Height46mm
Width180mm
Depth134mm

Box Contents

  • 1 x Power supply (240VAC – 12VDC)
  • 3 x 2.5 mm IR cable (1m long)
  • 1 x Itron HAB01 unit
Box contents